4/30/2024 0 Comments Install clover bootloader on ssd![]() I have been away from this forum for quite a while. So any tips to get Clover to start Windows installer, or even better if it’s possible to get windows to install straight to the SM951 AHCI without Clover, would be much appreciated! So now I can boot up into Clover 4664 and encouragingly it’s also seeing the new SM951 drive, but unfortunately it’s not seeing my Windows installation USB, no matter how many times I press F3 and/or reinsert. BTW the update link in the original post is broken and I think should link to silbliss’ great post on this. I’m not sure I need to as I have a AHCI and not a nvme drive, but I copied the NvmExpressDxe-64.efi from the Off directory to the other 2 directories and also to 2 new directories I created, drivers64 and drivers64UEFI. So I made an AIO USB boot drive using the discontinued 0.9.9.21 AIO Boot Creator (as the newgen version gave me an error). I even tried cloning my current Samsung 830 boot drive to the SM951, but Samsung magician doesn’t recognize the SM951, probably because it was an OEM only model… Hence I’m back here in the Clover-EFI bootloader method thread. I also tried formatting the SM951 (which is seen in Windows no problem and has device id DEV_A801) as GPT and as MBR but nothing would get the Windows installer to proceed. ![]() I tried all sorts of BIOS options, disabling SAS and SATA drives, even IDE instead of AHCI. I reused the Kingston KC100 PCIe card with the SM951 installed and it is seen as ‘mass storage’ by the BIOS, so I thought I’d be good to go, but when I boot from my USB Windows installer (made with microsoft media creation tool) the installer doesn’t see it as being bootable and won’t continue with the installation, “Ensure controller enabled in BIOS”. Please help me finally get my vintage Dell Precision T7400 workstation booting Windows 10 from my Samsung SM951 SSDĪs I’d previously had a lot of difficulties getting my Kingston KC1000 booting using Clover, I specifially purchased a MZHPV512HDGL-0000 version, which should be AHCI and not nvme and so it should be seen by my legacy non UEFI bios.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |